Modified fuel tank and cover are finished! You can see how the front CF cover follows the contours of the fuel tank. I think I will add some rubber trim around the bottom edge, as well as the forward edge of the carbon tail/seat section.
Forward tank mounts can be seen, bolted to the frame rail, just aft of the carbon cover.
If I was to do it again, I wouldn't bother with the raised seam in the mold. The seam ended up rough (that's why I painted it)... I can see now you can get away with such thin carbon fibre after pulling out of the mold, it will flex a bit to match the tank contours.
You can see the dzus fastener holding the front of the tank. This might be sufficient to keep it in place. I also thought about Velcro on the trailing edge of the carbon cover. I'll see... it might not be necessary.